Ricoh B082 Service Manual page 814

DEDICATED TRANSMISSION PARAMETERS
Switch 03
No FUNCTION
0 Initial Tx modem rate
to Bit 3 2 1 0 Setting (bps)
3 0 0 0 0 Not used
0 0 0 1 2,400
0 0 1 0 4,800
0 0 1 1 7,200
0 1 0 0 9,600
0 1 0 1 12,000
0 1 1 0 14,400
0 1 1 1 16,800
1 0 0 0 19,200
1 0 0 1 21,600
1 0 1 0 24,000
1 0 1 1 26,400
1 1 0 0 28,800
1 1 0 1 31,200
1 1 1 0 33,600
1 1 1 1 Disabled
Other settings: Not used
4-5 Not used
6 AI short protocol
0: Off
1: Disabled
7 Not used
Switch 04
No FUNCTION
0 Inch-mm conversion before tx
Bit 1 Bit 0
to
0 0
1
0 1
1 0
1 1
2 DIS/NSF detection method
to Bit 3 Bit 2
3
0 0
0 1
1 0
1 1
B547
If training with a particular remote terminal always
takes too long, the initial modem rate may be too
high. Reduce the initial Tx modem rate using these
bits.
For the settings 14.4 or kbps slower, Switch 04 bit 4
must be changed to 0.
Note: Do not use settings other than listed on the
If the setting is "Disabled", the bit switch setting is
used.
Do not change the settings.
Refer to Appendix B in the Group 3 Facsimile
Manual for details about AI Short Protocol.
If the setting is "Disabled", the bit switch setting is
used.
Do not change the setting.
The machine uses inch-based resolutions for
Setting scanning. If "inch only" is selected, the printed copy
Inch-mm may be slightly distorted at the other end if that
conversion machine uses mm-based resolutions.
available
Inch only
If the setting is "Disabled", the bit switch setting is
Not used
used.
Disabled
(0, 1): Use this setting if echoes on the line are
Setting interfering with the set-up protocol at the start of
First DIS or transmission. The machine will then wait for the
NSF second DIS or NSF before sending DCS or NSS.
Second DIS or
NSF
If the setting is "Disabled", the bit switch setting is
Not used
used.
Disabled
COMMENTS
left.
COMMENTS
106 SM