Ricoh B082 Service Manual page 135

3.11 PHOTOCONDUCTOR UNIT (PCU)
3.11.1 PCU
[C]
[A]
1. Open the front door.
2. Lower the by-pass tray, open the duplex unit, and open the transfer unit right
cover.
3. Spread a sheet of A4 or LTR size paper [A] on top of the open front door.
NOTE: This paper catches any loose toner that may fall from the PCU as it is
removed.
4. Loosen [B] ( x 1).
5. Rotate bracket [C] to the left.
6. Raise the release lever [D].
7. Hold the PCU [E] as shown and pull it out of the machine.
NOTE: If the right cover is to be left open, cover the drum with paper, or
remove the PCU and cover it with paper. Before you re-install the PCU,
align the brackets on the PCU with the rails above and make sure they
are engaged before you slowly push the PCU into the machine.
SM
PHOTOCONDUCTOR UNIT (PCU)
[B]
B079R500.WMF
[D]
3-27
[E]
B079R901.WMF
B079/B082