Ricoh B082 Service Manual page 751

Width and A4: A4 (8.3"), no reduction
reduction B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
I/O rate 0: 0 ms/line
25: 2.5 ms/line
5: 5 ms/line
Note:
"40" is displayed while receiving a fax message using AI short
protocol.
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02
No FUNCTION
0-3 Not used
4 File retention time
0: Depends on User Parameter
24 [18(H)]
1: No limit
5 Not used
6 Memory read/write by RDS
to Bit 7 6 Setting
7 0 0 Always disabled
0 1 User selectable
1 0 User selectable
1 1 Always enabled
System Switch 03
No FUNCTION
0 Length of time that RDS is
to temporarily switched on when
7
bits 6 and 7 of System Switch
02 are set to "User selectable"
System Switch 04
No FUNCTION
0 Program registration list output
key display selection
1-2 Not used
SM
10: 10 ms/line
20: 20 ms/line
40: 40 ms/line
COMMENTS
Do not change the settings.
1: A file that had a communication error will not be
erased unless the communication is successful.
Do not change the setting.
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked out,
but the user can temporarily switch RDS on to allow
RDS operations to take place. RDS will
automatically be locked out again after a certain
time, which is stored in System Switch 03. Note that
if an RDS operation takes place, RDS will not switch
off until this time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
COMMENTS
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of System
Switch 02 are set to "User selectable".
The default setting is 24 hours.
COMMENTS
This setting determines whether the key to print the
program registration list is displayed on the screen.
Do not change the settings.
43
BIT SWITCHES
SP No. 1-101-003
SP No. 1-101-004
SP No. 1-101-005
B547