Ricoh B082 Service Manual page 801

G4 Parameter Switch 09 - Not used (do not change these settings)
G4 Parameter Switch 0A - Not used (do not change these settings)
G4 Parameter Switch 0B
No. FUNCTION
0 Transport block size
to Bit 3 2 1
3 0 1 1
1 0 0
1 0 0
1 0 1
1 0 1
4-7 Not used
G4 Parameter Switch 0C - Not used (do not change these settings)
G4 Parameter Switch 0D
No. FUNCTION
0 Back-to-back test mode
to Bit 1 0 Setting
1 0 0 Off
1 0 ISDN L2 test mode
(TE mode)
Other settings - Not used
2-7 Not used
G4 Parameter Switch 0E - Not used (do not change these settings)
G4 Parameter Switch 0F - Not used (do not change these settings)
SM
This value must match the value set in the
0 Value other terminal. Note that this value must be
1 128 the same as the value programmed for the
0 256 packet size (G4 Parameter Switch 7, bits 0 to
1 512 3). Also, the transport block size is limited by
0 1024 the amount of memory in the remote terminal.
1 2048 Normally, do not change the default setting.
Do not change these settings.
When doing a back-to-back test or doing a
demonstration without a line simulator, use
these bits to set up one of the machines in TE
mode, and the other in NT mode
Please note that this machine can only be set
to TE mode.
After the test, return both bits to 0.
See "Back-to-back Testing" in the
Troubleshooting section for full details.
Do not change these settings.
93
BIT SWITCHES
COMMENTS
COMMENTS
B547