Ricoh B082 Service Manual page 230

SERVICE PROGRAM MODE
5.1.2 SERVICE TABLE KEY
Notation
[range / default / step]
(initial)
italics
*
1111
B079
B082
DFU
Japan only
LEF
SEF
(!6.2 Image Processing)
B079/B082
What it means
Example: [-9 ~ +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM
reset, and the value can be changed in 0.1 mm steps with each
key press.
Comments added for reference.
Value stored in NVRAM. After a RAM reset, this default value
(factory setting) is restored.
An SP number set in bold-italic denotes a "Special Service
Program" mode setting that appears only after entering the SP
mode by pressing and holding the  on the 10-key pad and then
the "Copy SP" on the touch-screen.
Denotes the 35 cpm model.
Denotes the 45 cpm model.
Denotes "Design or Factory Use". Do not change this value.
The feature or item is for Japan only. Do not change this value.
Long Edge Feed
Short Edge Feed
Refer to "6.2 Image Processing" in "6. Details".
Due to fundamental changes in how image processing
adjustment is done with Group 4 SP codes, more details are
provided in Section 6.
5-4 SM