Ricoh B082 Service Manual page 283

SP5 Mode Number
5859 9 Key 9
10 Key 10
5907* Plug & Play
5913 Switchover Permission Time
5914* Application Counter Display
Printer Counter
Fax Counter
Copy Counter
5915 Mechanical Counter Detection
5918* A3/DLT Counter Display
5923* Border Removal Area Switching
5958 Feed Clutch Start Timing
Adjustment
1* 1st, 2nd Feed Clutches
2* 3rd, 4th, LCT Feed
Clutches
3* Leading Edge Jam
Detection Start Timing
SM
SERVICE PROGRAM MODE TABLES
Function and [Setting]
Sets the brand name and the production name for
Windows Plug & Play. This information is stored in
NVRAM. If the NVRAM is defective or has been
replaced, these names should be registered
again.
To set the plug and play model name, enter the
model number, and then press
Initial: 3
Selects whether or not the total printer counter is
displayed in the UP mode.
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
Checks whether the mechanical counter inside
the inner cover is connected or not.
Display:
0: Not detected
1: Detected
2: Unknown
Sets the key press display for the counter key.
[0, 1 / 0 / --]
This setting has no relation to (SSP) SP5-104
A3/DLT Double Count.
Toggles between two settings that affect the
appearance of the pages for border removal and
printed facing pages: (1) Using the original area
as the allotted area, or (2) Using only the copy
paper as the allotted area.
[0, 1/ 0 / --]
0: Original area used as base
1: Copy used as the base
Adjusts the clutch timing to optimize the intervals
between fed sheets to reduce jams in the feed
unit. DFU
[35 ~ 57.5 / 42.5 / 2.5mm]
[19~34 / 26.5 /2.5 mm]
5-57

.
B079/B082