Ricoh B082 Service Manual page 325

4. Under "5857 Save Debug Log", press .
COPY : SP-5-857-002
Save Debug Log
Target (1:IC Card 2:HDD)
Initial 0
5. Press  to select the IC Card or press  to select the HDD, then press .
 Saves the debug log directly to the IC card inserted in the controller slot. If the machine
does not have an HDD unit, or if the HDD is temporarily disabled, be sure to use this
setting.

Saves the debug log to HDD.
NOTE: This setting is normally set to "2" for writing the debug log to the HDD.
Setting the Timing for Debug Log Acquisition
You can specify that errors related to specific events be recorded in the debug log.
NOTE: More than one event can be selected for retrieval.
1. Enter  then press .
SP5858 (Debug Save When) contains the following features:
1 Engine SC Error
2 Controller SC Error
3 Any SC Error
4 Jam
2. To save data for items 1, 2, or 4, press the appropriate key. The example below
shows the "Engine SC Error" selected after pressing .
COPY : SP-5-858-001
Debug Save When
Engine SC Error
OFF
Press "ON" then press .
SM
_2_
Saves data when an engine-related SC code is
generated.
Saves debug data when a controller-related SC Code is
generated.
Saves data only for the SC code that you specify by
entering code number.
Saves data for jams.
ON
5-99
USING THE DEBUG LOG
B079/B082