Removing And Installing Fuel Pump - BMW F 650 GS Repair Manual

1
2
•
Release ring (1) using wrench,
BMW No. 16 1 021.
•
Remove fuel-pump unit (3) with gasket (2).
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Make sure the fuel-pump unit is installed in the
correct position and that the fuel feed hose and
the fuel return hose are correctly routed.
•
Close hose clamps with pliers,
BMW No. 13 1 500.
X
Tightening torques:
Union nut to fuel tank ................................... 36 Nm
16 14 009
pump
– Remove fuel-pump unit (
– Remove the warning-contact switch.
– Remove the fuel strainer.
•
Installation is the reverse of the removal proce-
dure.
16 14 500 Removing and installing fuel strainer
– Remove fuel pump unit.
•
Using a screwdriver, pry fuel strainer (4) off the
pump.
•
Installation is the reverse of the removal proce-
dure.
3
L
Note:
Remove the warning contact switch for the fuel level
only along with the pump unit.
The reserve fuel capacity of the fuel tank can be ad-
justed by varying the height of the contact switch in
the tank.
4
E160061
Removing and installing fuel
16.8).
a
16.9