Setup Of Destination - Oki C810 Maintenance Manual

Oki Data CONFIDENTIAL

5.4.3 Setup of destination

[Checking method: Menu Map Print]
The destination is set prior to shipping out of a maintenance PCB. (Maintenance PCBs area
available for each destination.) Basically, you don't need to change the destination settings.
The important information about settings will be cleared if you change the destination
setting.
Note! This setting is stored on the EEPROM of the CU PCB.
1. Setup on the operation panel: Start the printer in the maintenance mode, and set
the destination.
• Turn on the power with the MENU
• By pressing ENTER key after "SYSTEM MAINTE" is displayed briefly,
"ENTER PASSWORD" will be displayed. By pressing a password, the
display will change to "OKIUSER".
• Press the ENTER key.
• "OEL" will appear in the lower line of the LCD.
• Press the ENTER key, select the destination by operating the MENU
or MENU
• Press the BACK key to define the setting. "JPI"
• Press the BACK key twice, or the ONLINE key once. This will cause the
printer to restart with the destination modified.
2. Explanation
This printer is ROM used in common for domestic and overseas markets.
This setting is stored on the EEPROM of the CU PCB.
When the version number of the program ROM is changed, the setting will be
reset to the default value.
44072903TH Rev.1
and MENU
key held down.
key, and press the ENTER key.
5. MENTENANCE MENUS
138 /