Autotest On Twisted Pair Cabling - Fluke CableIQ User Manual

Autotest on Twisted Pair Cabling

A wiremap adapter or remote ID locator must be
connected to the end of the cabling for the
wiremap to be completely verified.
The Autotest does not support use of multiple
remote ID locators (the MultiMap function).
If you use patch cords at the near or far end
during an Autotest, Fluke Networks recommends
patch cords at least 2 m long.
The Autotest will not run if the tester is
connected to a data port, or detects voltage or a
short on the cabling.
1 Turn on the tester. Turn the rotary switch to
AUTOTEST.
2 To change the tests to run,
3 Connect the tester and wiremap adapter or ID locator
to the cabling. Figures 6, 7, and 8 show typical
connections.
P
4 Press . The Autotest proceeds when a wiremap
adapter or ID locator is detected. The analog toner
turns on if neither is detected.
Notes
H
or . See page 18.
J
Qualifying Cabling with the Autotest
5 To save the test:
a. Press .
K S
AD
b. Use and
or Outlet field for editing. You can enter up to
17 characters in each field. See Figure 4 on page
13 for details on editing text.
To see a list of predefined labels for the
highlighted field, press
AD
, or SHIFT +
B C
H
list. Use or
J
c. On the Enter ID screen, press
the results with the Site, Location, and Outlet
entries shown.
The last character of the Outlet string increments
each time you save an Autotest.
to select the Site, Location,
H
AD
J List. Use
to move through the
to select an entry.
to save
K S
Note
,
19