Fluke CableIQ User Manual page 37

Crossed pairs. In this case, pairs 1,2
and 3,6 are crossed. This is likely
caused by mixing 568A and 568B
cables.
Detection of crossed pairs requires a
far-end adapter.
avv22.bmp
Telephone cable with pairs 3,6 and
4,5 crossed. This crossover is normal
for the flat cords used to connect
telephones to wall outlets.
Figure 10. Typical Wiremap Screens (cont.)
Qualifying Cabling with the Autotest
avv03.bmp
Bridge tap detected.
Bridge taps are allowed for the Telco
test, but cause a failure for network
tests.
avv32.bmp
27