Replacing The Batteries - Fluke CableIQ User Manual

CableIQ Qualification Tester
Users Manual
To update the tester's software:
1 If you want to save any of the Autotests stored in the
tester, use CableIQ Reporter software to upload them
to a PC.
2 Download the latest versions of CableIQ Reporter
software and the CableIQ update file from the Fluke
Networks website, or contact Fluke Networks to get
the files by other means. The files are available at
www.flukenetworks.com/support. Save the files to
your hard drive.
3 Install the latest version of CableIQ Reporter on your
PC.
4 Turn on the tester and connect it to the PC using the
USB cable provided.
5 On the CableIQ Reporter menu bar, select Utilities >
Update CableIQ Software , locate and select the
CableIQ update file (.ref extension); then click OK.
6 To verify the update, turn the rotary switch to SETUP;
then select Version Information.
If the software update fails, repeat steps 4 through 6. If it
fails again, contact Fluke Networks for assistance.
64

Replacing the Batteries

Replace the 4 AA batteries when the message Low
Batteries! appears.
Install new batteries within 3 minutes of
removing the old batteries. If you leave the
batteries out for more than 3 minutes, the time
and date may need to be reset.
The tester's battery gauge is most accurate when
alkaline batteries are installed.
Figure 26 shows how to replace the batteries.
Note