Table of Contents
Advertisement
CableIQ Qualification Tester
Users Manual
Using the Toner
You can use the tester with an optional tone probe to
locate cables in bundles, at patch panels, or behind walls.
Use the tester's IntelliTone
Networks IP100 or IP200 tone probe. The digital
IntelliTone signal is easier to detect at a distance than
analog tones, and its frequency and encoding eliminate
cable misidentification due to signal bleed and radiated
or ambient noise.
The tester's other tones, which are analog, can be
detected by most tone probes.
To use the toner:
1
Connect the tester to twisted pair or coaxial cabling
as shown in Figure 20.
2
Turn the rotary switch to TONE.
48
™
functions with a Fluke
3
Use
DA
to highlight a tone:
IntelliTone: One-note and two-note IntelliTone
signals for use with a Fluke Networks IP100 or IP200
probe.
Tone 1, Tone 2, Tone 3, Tone 4: Multi-note, analog
tones detectable by most tone probes.
For tones 1 through 4, press
tones.
4
To tone coaxial cable, press
5
Use the probe to search for the cable.
For details on using the IntelliTone function, see the
tone probe's documentation.
The toner also turns on when you start an Autotest with
no adapter or ID locator connected.
to hear the
J X
K c
.
Hide quick links:
Advertisement
Table of Contents
