Testing Twisted Pair Cabling
Turn on the tester.
1
2
MicroScanner
: If the tester is already on and in coaxial
test mode (
), press
mode (
).
Connect the tester and wiremap adapter or ID locator to
2
the cabling as shown in Figures 7 through 21.
The test runs continuously until you change modes or turn
the tester off.
You can measure length without connecting a far
end adapter; however, an adapter is required for a
complete wiremap test.
If the PoE indicator appears, set the tester to PoE
mode. See page 38.
to switch to twisted pair test
Notes
Testing Twisted Pair Cabling
Patch panel
RJ45 patch
cords
Wiremap
adapter
Figure 7. Connecting to Twisted Pair Network Cabling
Wall
outlet
EGK03.EPS
15