NEC NC1700L Installation Manual page 66

Setting Up Your Projector and Chiller Unit
Compatible Cables and Solderless Terminals
Solderless terminals and screw fastening torques compatible with the terminal block are specified below. This specifies the
model name of the recommended solderless terminals. Use these parts or equivalent parts. If you are unable to use the recom-
mended solderless terminals, ensure that you use terminals of the dimensions shown in the following diagram.
CAUTION
Always use solderless terminals with the dimensions as shown in the following diagram. The use of parts with dimensions
other than as designated creates a risk of the AC power supply unit short circuiting due to the terminal block generating
heat and melting because the terminal block of the chiller unit cannot be attached correctly.
• Power terminal (Black)
Item
Thickness of compatible wiring
Solderless terminal dimensions
Tightening torque
Solderless terminal dimensions
Solderless terminal
recommended part (J.S.T parts)
J.S.T: J.S.T Manufacturing Co, Ltd.
66
Power terminal L, N
IEC/EN
2.0 mm
2
M4
1.3 N•m
Max 6.8
Units: mm
–
2 M4
Ground terminal G
Standards
UL
AWG14
1.0 N•m
Max. 3.3
CSA (C-UL)
φ4.3
Min. 6.3