Table of Contents
Advertisement
4. LCD Menu
This chapter describes the menus displayed in the LCD screen on the projector's control panel and their functions. For basic
operations of menus, refer to the projector's operation manual.
4-1. List of Menu
Menus in parentheses are menus for our service personnel. Normally, these menus cannot be used. If you are logged in to the
projector with Installation privileges, you cannot use [FactoryDefault] - [LAN] (page 93).
Main menu
Title Select
"Title Memory Name"
TEST Pattern
Configuration
Light Setup
Lens Control
Reset
(Setup)
Installation
(Note)
Submenu
Selects the title of the signal to be projected.
Selects the test pattern to be projected.
Adjust
Adjusts light brightness.
Lens Position
Adjusts the position of the projected screen.
Focus Zoom
Adjusts the size and focus of the projected screen.
(FactoryDefault)
Returns the settings to their default values. Selects between
preset buttons and titles only, LAN settings only and all settings.
Filter Cleaning
Initializes the air filter usage time (for confirming the filter
cleaning time).
(Fan Usage)
Initializes the usage time of the fan.
(Light)
Initializes the usage time of the light source.
(Phosphor)
Initializes the usage time of the phosphor.
(Diffuser)
Initializes the usage time of the diffuser.
(Chiller)
Initializes the usage time of the chiller unit.
(Chiller Fan)
Initializes the usage time of the chiller unit fan.
(Douser Count)
Resets the number of times the douser has been used.
Douser Setup
Sets the douser open/close state.
Panel Key Lock
Locks the buttons on the projector's control panel so that they
cannot be operated.
Auto Key Lock
Enables or disables Auto Key Lock.
3D Connector
Sets the signal input terminal for a 3D image system (3D terminal
or GPI/O terminal).
Sets the video input port for 3D video systems.
Off Timer
Sets the time until the projector power is turned off automatically.
Message
Sets the time to display the message indicating the light
replacement cycle.
Silent Mode
Selects whether to use the status indicator, buzzer, indicators on
the control panel and backlight.
(Option Slot)
Configures the device installed in slot (only when the projector is
in standby mode).
(Orientation)
Sets the projection method.
Lens Type (Note)
Sets the type of lens (supports or does not support the lens
memory function) attached to the projector.
Lens Calibrate
Performs calibration on lens that support the lens memory
(Note)
function (only when the projector power is turned on).
Lens Center (Note)
Moves the lens shift position to the center (only when the
projector power is turned on).
(Baudrate)
Sets the PC control connector (RS-232) data transmission speed
(bps).
(Date/Time)
Sets the date and time on the projector.
(Fan Speed Mode)
Sets the cooling fan operating mode.
(Service Adj.)
(Only when the projector is in standby mode)
This is used during shadow adjustment and lens mount
adjustment (focus balance adjustment).
(LD Calibrate)
Performs calibration of the light module when the light module
has been replaced (only when the projector power is turned on).
Description
Reference
page
91
91
92
92
92
93
93
94
94
94
94
94
95
95
95
96
96
96
97
97
98
99
99
100
100
100
101
101
102
102
102
89
Hide quick links:
Advertisement
Table of Contents
