NEC NC1700L Installation Manual page 7

Peripheral Devices and Connecting Cables
Use shielded cables for the cables connecting the IMB with
peripheral devices (GPI, GPO, AES cables). If you use a non-
shielded cable, there is a risk that radio interference may
occur.
WARNING TO CALIFORNIA RESIDENTS:
Handling the cables supplied with this product will
expose you to lead, a chemical known to the State of Cali-
fornia to cause birth defects or other reproductive harm.
WASH HANDS AFTER HANDLING
Light Module
1. A light module containing multiple laser diodes is
included in the product as the light source.
2. These laser diodes are sealed in the light module. No
maintenance or service is required for the performance
of the light module.
3. End user is not allowed to replace the light module.
4. Contact qualified distributor for light module replace-
ment and further information.
About High Altitude mode
• Set [Fan Speed Mode] to [High Altitude] when using the
projector at altitudes approximately 5500 feet/1600 meters
or higher.
Using the projector at altitudes approximately 5500
feet/1600 meters or higher without setting to [High Alti-
tude] can cause the projector to overheat and the projec-
tor could shut down. If this happens, wait a couple minutes
and turn on the projector.
• Using the projector at altitudes less than approximately
5500 feet/1600 meters and setting to [High Altitude] can
cause the projector to overcool, causing the image to
flicker. Switch [Fan Speed Mode] to [Auto].
• Using the projector at altitudes approximately 5500
feet/1600 meters or higher can shorten the life of internal
parts.
Disposing of your used product
EU-wide legislation as implemented in each
Member State requires that used electrical
and electronic products carrying the mark
(left) must be disposed of separately from nor-
mal household waste.
This includes projectors and their electrical
accessories. When you dispose of such prod-
ucts, please follow the guidance of your local
authority and/or ask the shop where you pur-
chased the product.
After collecting the used products, they are
reused and recycled in a proper way. This
effort will help us reduce the wastes as well as
the negative impact to the human health and
the environment at the minimum level.
The mark on the electrical and electronic prod-
ucts only applies to the current European
Union Member States.
For EU: The crossed-out wheeled bin implies
that used batteries should not be put to the
general household waste! There is a separate
collection system for used batteries, to allow
proper treatment and recycling in accordance
with legislation.
According the EU directive 2006/66/EC, the
battery can't be disposed improperly. The
battery shall be separated to collect by local
service.
For questions relating to unclear points or repairs
Contact your dealer or the following support branch for
questions relating to unclear points, malfunctions and repairs
of the product.
In Europe
Company Name: NEC Display Solutions Europe GmbH
Address: Landshuter Allee
Germany
Telephone: +49 89 99699 0
Fax Line: +49 89 99699 500
Email Address: info@nec-displays.com
WEB Address: http://www.nec-display-solutions.com
In North America
Company Name: NEC Display Solutions of America, Inc.
Address: 500 Park Boulevard, Suite 1100 Itasca, Illinois
60143, U.S.A.
Telephone: +1 800 836 0655
Fax Line: +1 800 356 2415
Email Address: pjtechsupport@necdisplay.com
WEB Address: http://www.necdisplay.com/
Important Information
12-14, D-80637 Munich,
7