NEC NC1700L Installation Manual page 48

Before Setting Up Your Projector and the Chiller Unit
3
Remove the side cover.
The bottom part of the side cover is fixed in place by hooks (in 3 locations). Remove it by using the following
procedure.
1. Hold the upper part and the left and right edges of the side cover and pull it towards you.
There is a handhold on the left side of the side cover. The side cover is affixed to the projector by tabs (7
locations) and hooks (3 locations). When removing the cover, pull it out straight towards you so that the tabs do
not get bent.
2. Using the bottom edge of the side cover as a pivot, pull the top side of the cover towards
you.
Since there are hooks at the bottom of the side cover, take care to avoid applying too much force when tilting the
cover. Tilting the cover towards you will loosen the attachment between the hooks and the projector.
3. Once the hooks have come loose, remove the cover from the projector.
Handhold
This completes removing the side cover. To mount the side cover, perform the removal procedure in reverse. Make sure that
you do not forget to tighten the screws or to lock the key lock.
48
Tab (7 locations)
Side cover (back side)
Handhold
Hook (3 locations)