Switching Using The Matrix Mode - Roland XS-62S Owner's Manual

Video Operations

Switching Using the MATRIX Mode

You can individually select the video that is output to each bus
(PGM/1, PVW/2, AUX/3 buses).
1.
To select the video that is output to the PGM/1
bus and PVW/2 bus, press the [SW MODE] button
several times to make it light yellow.
In this state, the bus selected by the upper row of cross-point
buttons is "PGM/1, " and the bus selected by the lower row is
"PVW/2. "
2.
Press a cross-point button (upper row) to select
the channel that is output to the PGM/1 bus, and
press a cross-point button (lower row) to select the
channel that is output to the PVW/2 bus.
The channels you pressed are lit yellow, and the video is output to
the PGM/1 bus and PVW/2 bus.
PGM/1 bus:
Channel 1
PVW/2 bus:
Channel 4
3.
To select the video that is output to the AUX/3 bus,
press the [SW MODE] button several times to make
it light green.
The "AUX/3" bus will be the bus selected by the cross-point
buttons (upper row).
4.
Press the cross-point button (upper row) of the
channel number that you want to send to the
AUX/3 bus.
AUX/3 bus:
Channel 1
The channels you pressed are lit yellow, and the video is output to
the AUX/3 bus.
MEMO
5 To output the still image or monochrome video (background
color), use the [PinP] button for channel 7 or the [DSK]
button for channel 8 (p. 19).
5 When the following conditions are satisfied, the channels
are switched with a black fade effect.
5 When in MATRIX mode
5 When the TRANSITION TYPE is "MIX" or "WIPE"
5 When the TRANSITION TIME is other than "0.0sec. "
5 In MATRIX mode, the [TAKE] button does nothing.
18
Selecting the Channel for Output to the AUX/3
Bus
Here's how to select the channel that is output to the AUX/3 bus.
1.
Press the [SW MODE] button several times to make
it light green.
The "AUX/3" bus will be the bus selected by the cross-point
buttons (upper row).
2.
Press the cross-point button (upper row) of the
channel number that you want to send to the
AUX/3 bus.
AUX/3 bus:
Channel 1
The channels you pressed are lit yellow, and the video is output to
the AUX/3 bus.
MEMO
5 In PGM-PST mode or DISSOLVE mode, the cross-point
button that you press is lit red. In MATRIX mode, it is lit
yellow.
5 The video of the AUX/3 bus can be output from the SDI
OUT connector and the HDMI OUT connector. If you
want to output the AUX/3 bus, set the bus assignment of
the respective connector to "AUX/3. " For details, refer to
"Selecting the Video of the Bus to Output" (p. 16).
5 The channel that is output to the AUX/3 bus can be
selected regardless of the video switching mode (PGM-PST,
DISSOLVE, MATRIX).
5 To adjust the volume of the audio of the AUX/3 bus, use
[MENU] button 0 "AUDIO OUTPUT" 0 "AUX" 0 "AUX
LEVEL. "
5 In the multi-view monitor, the "AUX" symbol is shown for the
input channel that is being sent to the AUX/3 bus.