Controlling Fader Operation Automatically (Auto Mixing) - Roland XS-62S Owner's Manual

Controlling Fader Operation
Automatically (Auto Mixing)
This automatically controls fader operations that normally are
performed by an operator (Auto Mixing feature). It lets you rely on
the XS-62S to perform complex fader operations, enabling use in
circumstances where no dedicated operator is assigned.
This is especially useful for meetings, discussions, debates, and
other situations where multiple microphones are used.
MEMO
Auto mixing can independently control the output to the
PGM/1 bus and the output to the PVW/2 bus.
1.
Follow the procedure in "Adjusting the Head Amp
Gain" (p. 25) to adjust the input gain for channels 1
through 4.
2.
Press the [AUTO MIXING] button to turn on the
Auto Mixing feature (making the button light up).
3.
To turn off the Auto Mixing feature, press the [AUTO
MIXING] button a second time.
Adjusting the Auto Mixing Effect
If you want to adjust the auto mixing volume control to your
preferred balance, you can make fine adjustments for each input.
Select the [MENU] button 0 "AUDIO AUTO
1.
MIXING."
2.
Select the audio to use with Auto Mixing, then use
the [VALUE] knob to set it to "ON."
Set audio where Auto Mixing is not needed, such as background
music, to "OFF. "
3.
Press the [VALUE] knob to apply the setting.
4.
Set "WT" (weight), then use the [VALUE] knob to
set the priority level for volume-level distribution
(from 0 to 100%).
If there is audio that you want to make more prominent,
such as when you want to raise the volume level of an emcee
microphone, raise the weight level of that audio to emphasize it,
and lower the weight level for other audio.
MEMO
5 On audio to which Auto Mixing is applied, setting the
weight level to "0%" results in no audio output.
5 When air-conditioner noise or the like is a concern, set the
weight level to a low value.
5.
Press the [VALUE] knob to apply the setting.
Repeat steps 4 through 7 as needed.
6.
Press the [MENU] button to quit the menu.
Audio Operations
29