Selection Of The Aerodr Detector - Konica Minolta AeroDR System Operation Manual

3.4 Registration and selection of the AeroDR Detector
3 .4 .4 Selection of the AeroDR
Detector
An AeroDR Detector is selected as follows depending
on the number registered on each image processing
controller.
Number of reg-
istered AeroDR
Detectors
• AeroDR Detector is selected
automatically when that AeroDR
Detector is ready to be selected.
1 • The AeroDR Detector is not se-
lected if it is not set in a wall stand
or table that matches the order
information.
• The AeroDR Detector that was
selected immediately beforehand
will be selected automatically if it is
ready to be selected.
Multiple
• If there is no AeroDR Detector in
the wall stand or table that matches
the order information, no AeroDR
Detector will be selected.
HINT •••••••••••••••••••••••••••••••••••••
• The LED (green) of the selected AeroDR Detector is lit.
• • •• • • •• • • •• •••••••••••••••••••••••••••••••••• •••••••
Selection method
3 .4 .5 Manual selection of the
AeroDR Detector
Selecting the AeroDR Detector manually is performed
with the following procedure.
1
Press the selection switch of the AeroDR
Detector that will be used for 2 seconds or
longer .
2
After selection is completed, the LED
(green) of the AeroDR Detector is lit .
Reference
•••••••••••••••••••••••••••••••••• • ••
• The AeroDR Detector can also be selected manually
from the image processing controller. For details, refer
to the "Operation Manual" of the image processing
controller.
•••••••••••••••••••••••••••••••••••••••••••••••••• •• •
66
Selection switch