Konica Minolta AeroDR System Operation Manual page 48

3.1 Startup and shutdown
 AeroDR Generator Interface Unit2
• When the power switch of the AeroDR Inter-
face Unit is turned on, power is supplied to the
AeroDR Generator Interface Unit2, and the LED
(green) on the AeroDR Generator Interface
Unit2 will flash.
• When using the AC adapter, turn the power
switch of the AeroDR Generator Interface Unit2
on, and confirm that the LED (green) on the
AeroDR Generator Interface Unit2 is flashing.
Power switch
 AeroDR Battery Charger
• When the power cable is connected to the wall
outlet, power of the AeroDR Battery Charger
is turned on. Confirm that the LED (green) is
slowly flashing.
LED (green)
LED (green)
LED (green)
 AeroDR Battery Charger2
• Turn the power switch of the AeroDR Battery
Charger2 on, and confirm that the LED (green)
is slowly flashing.
LED (green)
 AeroDR Access Point
• When the power switch of the AeroDR Interface
Unit or AeroDR Interface Unit2 is turned on,
power is supplied to the AeroDR Access Point,
and the LED (umber) on the AeroDR Access
Point will light.
LED (umber)
 Access Point
Reference •••••••••••••••••••••••••••••••••• • ••
• When using a general-purpose access point, refer to its op-
eration manual.
•••••••••••••••••••••••••••••••••••••••••••••••••• • ••
 Image processing controller
• Start the image processing controller by turning
the power switch of the image processing con-
troller on.
48
Power switch