Konica Minolta AeroDR System Operation Manual page 61

•••••••••••••••••••••••••••••••••••••
HINT
• AeroDR 1717HQ is inserted
Exposure
side
• AeroDR 1012HQ is inserted
Exposure
side
•• • •• •• • •• •• •••••••••••••••••••••••••••••••••••••••••
3
Once the AeroDR Detector is inserted cor-
rectly and charging starts, the LED (blue)
on the AeroDR Battery Charger2 will flash
or light .
• The LED (blue) on the AeroDR Battery Charger2
changes according to the level of battery power
of the AeroDR Detector.
Battery level
2% or less
Slow flashing (blue)
3 to 49%
Lit and Slow flashing (blue)
50 to 79%
Lit and Slow flashing (blue)
80% or more
Lit (blue)
4
5
LED display
61
3.3 Charging of AeroDR Detector
Once charging of the AeroDR Detector
is completed, all the LEDs (blue) on the
AeroDR Battery Charger2 will turn on .
•• •• •• •• ••• •• •• •• ••• •• •• •• •• ••• •• • • • •
IMPORTANT
• Handle the AeroDR Detector with extreme care when
inserting it into the AeroDR Battery Charger2.
• The wired connection connector of the AeroDR De-
tector may become warm right after charging on the
AeroDR Battery Charger2. This often occurs during
charging and is not a malfunction.
• ••• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• •• •• • • •
HINT •• •• •• •• ••• •• •• •• ••• •• •• •• •• ••• •• • • • •
• If there is any problem during charging, the LED (or-
ange) on the AeroDR Battery Charger2 will light. Also,
charging will stop when an error occurs.
• ••• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• •• •• • • •
Remove the AeroDR Detector from the
AeroDR Battery Charger2 .
• Tilt the AeroDR Detector in the direction shown
in the following figure and remove it.
IMPORTANT •• •• •• •• ••• •• •• •• ••• •• •• •• •• ••• •• • • • •
• As the AeroDR Detector is locked by a magnet, do not
pull it out horizontally or vertically.
• ••• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• •• •• • • •