Konica Minolta AeroDR System Operation Manual page 47

3 .1 .2 Startup of this device
The startup methods of this device are as follows.
 AeroDR Detector
• If the AeroDR Detector is inserted into the
AeroDR Battery Charger or AeroDR Battery
Charger2 with a wireless connection, the
AeroDR Detector should be removed.
• For a wired connection, confirm that the AeroDR
UF Cable or the AeroDR I/F Cable is connected
securely to the wired connection connector of
the AeroDR Detector.
• Next, press the power switch of the AeroDR De-
tector for 2 seconds and turn it on, and confirm
that the LED (green) is slowly flashing or lit.
IMPORTANT •••••••••••••••••••••••••••••••••••••
• Do not use a sharp object to operate the switch; doing so
may damage the AeroDR 2 1417HQ and AeroDR 2 1417S.
•• • •• •• • •• •• •••••••••••••••••••••••••••••••••••••••••
 AeroDR Interface Unit
• Turn the power switch of the AeroDR Interface
Unit on, and confirm that the LED (green) lights.
LED (green)
Power switch
LED (green)
Power switch
 AeroDR Interface Unit2
• Turn the power switch of the AeroDR Interface
Unit2 on, and confirm that the Detector Connec-
tion LED (green) and Generator Interface LED
(green) light.
Detector Connection LED (green)
Generator Interface LED (green)
• ••• •• •• •• ••• •• •• •• •• ••• •• •• •• ••• • • • •
HINT
• It takes time for the Generator Interface LED (green)
to light.
• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• •• ••• •• •• • • • • •
 Hub
Reference • ••• •• •• •• ••• •• •• •• •• ••• •• •• •• ••• • • • •
• When using a general-purpose hub, refer to its opera-
tion manual.
• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• •• ••• •• •• • • • • •
 AeroDR Generator Interface Unit
• When the power switch of the AeroDR Inter-
face Unit is turned on, power is supplied to the
AeroDR Generator Interface Unit, and the LED
(green) on the AeroDR Generator Interface Unit
will flash.
LED (green)
47
3.1 Startup and shutdown
Power switch