Table of Contents
Advertisement
1.
Click System -> SNTP -> Servers
2.
The SNTP Servers screen is displayed as in Figure 3-21.
The page includes the following fields:
• SNTP Server -- Enter a user-defined SNTP server IP addresses or hostname. Up to eight SNTP servers can be
defined. This field can contain 1 - 158 characters.
• Poll Interval -- Enables polling the selected SNTP Server for system time information, when enabled.
• Encryption Key ID -- Specifies the Key Identification used to communicate between the SNTP server and
device. The range is 1 - 4294967295.
• Preference -- The SNTP server providing SNTP system time information. The possible field values are:
• Primary -- The primary server provides SNTP information.
• Secondary -- The backup server provides SNTP information.
• Status -- The operating SNTP server status The possible field values are:
• Up -- The SNTP server is currently operating normally.
• Down -- The SNTP server is currently not operating normally.
• Unknown -- The SNTP server status is currently unknown.
• Last Response -- The last time a response was received from the SNTP server.
• Offset -- Timestamp difference between the device local clock and the aquired time from the SNTP server.
• Delay -- The amount of time it takes to reach the SNTP server.
• Remove -- Removes a specific SNTP server from the SNTP Server list, when selected.
SNTP Interface Settings
The SNTP Broadcast Interface Table contains fields for setting SNTP on different interfaces.
To open SNTP Broadcast Interface Table screen perform the folling:
1.
Click System -> SNTP -> Interface Settings
2.
The SNTP Interface Settings screen is displayed as in Figure 3-22.
Figure 3-21 SNTP Servers screen
22
Advertisement
Table of Contents
