Table of Contents
Advertisement
• The port's 802.1p priority is equal to LAGs 802.1p priority.
• QoS Trust is not disabled on the port.
• GVRP is not enabled.
?
Ports can be configured as LACP ports only if the ports are not part of a previously configured LAG.
Note
:
The device uses a hash function to determine which frames are carried on which aggregated-link member. The hash
function statistically load-balances the aggregated link members. The device considers an Aggregated Link as a single
logical port.
Each Aggregated Link has an Aggregated Link Port Type, including Gigabit Ethernet ports. Ports can be added to an
Aggregated Link only if they are the same port type. When ports are removed from an Aggregated Links, the ports revert
to the original port settings.
The Link Aggregation page contains links to the following topics:
• LACP Parameters
• LAG Membership
LACP Parameters
The LACP Parameters page contains fields for configuring LACP LAGs. Aggregate ports can be linked into
link-aggregation port-groups. Each group is comprised of ports with the same speed.
Aggregated Links can be manually setup or automatically established by enabling Link Aggregation Control Protocol
(LACP) on the relevant links.
To open LACP Parameters screen perform the folling:
1.
Click Switch -> Link Agreegation -> LACP Parameters
2.
The LACP Parameters screen is displayed as in Figure 3-67
The page includes the following fields:
• LACP System Priority (1-65535) -- The LACP priority value for global settings. The possible range is 1- 65535.
The default value is 1.
Figure 3-67 LACP Parameters
77
Advertisement
Table of Contents
