Time Setting; Time Configuration; Sntp Server - Planet Networking & Communication SGS-5240 Series User Manual

User's Manual of SGS-5240 Series Managed Switch

4.8.8 Time Setting

4.8.8.1 Time Configuration

The Device Management > Time Setting > Time Configuration page is used to set the system time on the switch manually
without using SNTP.
◆Current Time – Shows the current time set on the switch.
◆Hours – Sets the hour. (Range: 0-23)
◆Minutes – Sets the minute value. (Range: 0-59)
◆Seconds – Sets the second value. (Range: 0-59)
◆Month – Sets the month. (Range: 1-12)
◆Day – Sets the day of the month. (Range: 1-31)
◆Year – Sets the year. (Range: 1970-2037)

4.8.8.2 SNTP Server

The Device Management > Time Setting > SNTP Server page is used to specify the IP address for up to three SNTP time
servers.
◆SNTP Server IP Address – Sets the IPv4 or IPv6 address for up to three time servers. The switch attempts to update the time
from the first server, if this fails it attempts an update from the next server in the sequence.
278