Planet Networking & Communication WGSW-24010 User Manual page 12

1. On "console>" prompt, enter "enable" to enable the privileged commands. The original prompt, "console>" will
become "console#". As show in Figure 3-2.
2. On "console#" prompt, enter "configure" to enter the configuration mode. The prompt "console#" then
become "console(config)#". As show in Figure 3-3.
3. On "console(config)#" prompt, enter "interface vlan 1" to configure the default IEEE 802.1 VLAN. The prompt
"console(config)#" then change to "console(config-if)#". As show in Figure 3-4.
Figure 3-1 Console Main Screen of WGSW-24010
Figure 3-2 Enable privileged commands
Figure 3-3 Enter configuration mode
7