Table of Contents
Advertisement
The page includes the following fields:
• Interface -- Port or LAG number added to a protocol group.
• Group ID -- Protocol group ID to which the interface is added. Protocol group IDs are defined in the Protocol
Group Table.
• VLAN ID (1-4095) -- Attaches the interface to a user-defined VLAN ID. The VLAN ID is defined on the Create a
New VLAN page. Protocol ports can either be attached to a VLAN ID or a VLAN name.
?
VLAN 4095 is the discard VLAN.
Note
:
?
Protocol ports can be defined only on ports that are defined as General in the VLAN Port Membershi p
Note
:
Table page.
GVRP Parameters
GARP VLAN Registration Protocol (GVRP) is specifically provided for automatic distribution of VLAN membership
information among VLAN-aware bridges. GVRP allows VLAN-aware bridges to automatically learn VLANs to bridge ports
mapping, without having to individually configure each bridge and register VLAN membership.
To ensure the correct operation of the GVRP protocol, it is advised to set the maximum number of GVRP VLANs equal to
a value which significantly exceeds the sum of:
• The number of all static VLANs both currently configured and expected to be configured.
• The number of all dynamic VLANs participating in GVRP, both currently configured (initial number of dynamic
GVRP VLANs is 128) and expected to be configured.
The GVRP Global Parameters page enables GVRP globally. GVRP can also be enabled on a per-interface basis.
To open GVRP Parameters screen perform the folling:
1.
Click Switch -> VLAN -> GVRP Parameters
2.
The GVRP Parameters screen is displayed as in Figure 3-66
Figure 3-65 Protocol Port Table screen
75
Advertisement
Table of Contents
