Table of Contents
Advertisement
This section describes the functionalities of the Switch 's components and guides how to install it on the desktop or shelf.
Basic knowledge of networking is assumed. Please read this chapter completely before continuing.
2.1 Product Description
The WGSW-24010 is a powerful, high-performance 24G + 1 Mini-GBIC 10/100/1000Mbps Fast Ethernet and Gigabit
managed switch with twenty-four 10/100/1000Mbps ports and 1-SFP Mini-GBIC interfaces. The SFP Mini-GBIC interfaces
for fiber extension is ideal for backbone connection to other workgroup products.
2.1.1 Product Overview
All RJ-45 copper interfaces of WGSW-24010 support 10/100/1000Mbps Auto-Negotiation for optimal speed detection
through RJ-45 Category 6, 5 or 5e cables. Also, all the ports support Auto-MDI/MDI-X that can detect the type of
connection to any Ethernet device without requiring special straight or crossover cables.
The powerful management capabilities of the device can be managed using the console, telnet or the web. SNMP MIB-II.
Entity MIB and RMON are supported to provide maximum management functionality, providing a useful platform for
system managers to monitor and administer the system efficiently. A complete set of diagnostic LED's are provided to
simplify troubleshooting and provide a visible operating status. The IEEE 802.1Q VLAN tagging feature makes logically
separating nodes easier with up to 256 VLAN groups allowed. Port trunking is also supported with up to 8 trunk groups on
single switch. To simplify network troubleshooting when using sniffer software, the WGSW-24010 also supports port
mirroring to duplicate up to 2 ports' transmitting and receiving packets to a specified sniffer port.
2.1.2 Switch Front Panel
Figure 2-1 shows a front panel of the Switch.
2.1.3 LED Indicators
LED
Color
PWR
Green
LNK/ACT
Green
1000
Orange
FDX
Green
2.1.4 Switch Rear Panel
The rear panel of the Switch indicates an AC inlet power socket, which accepts input power from 100 to 240VAC,
50-60Hz.
Figure 2-1 WGSW-24010 front panel
Lights to indicate that the Switch has power.
Lights to indicate that the Switch is successfully connecting to the network.
Blinks to indicate the Switch is actively receiving or sending the data over the port.
Lights to indicate that the port is operating at 1000 Mbps.
Off to indicate that the port is operating at 100Mbps or 10 Mbps while the port 's Link is on.
Lights to indicate that the port is operating in full duplex mode.
Off to indicate that the port is operating in half duplex mode.
Figure 2-3 WGSW-24010 Rear Panel
2. INSTALLATION
Function
ON
OFF
POWER
100~240V AC
50~60Hz
3
Advertisement
Table of Contents
