General Descriptions For Pm Procedure - Toshiba e-STUDIO520 Service Handbook

4.2

General Descriptions for PM Procedure

Perform the preventive maintenance in the following timing.
e-STUDIO520/523:every 450,000 sheets
e-STUDIO600/603:every 500,000 sheets
e-STUDIO720/723:every 575,000 sheets
e-STUDIO850/853:every 600,000 sheets
(1) Preparation
• Ask the user about the current conditions of the equipment and note them down.
• Before starting maintenance, make some sample copies and store them.
• See the replacement record and check the parts to be replaced in the PM support mode (6S-
2) or list printing mode (9S-103).
6S-2 : [6] + [START] + [POWER] ON
9S-103 : [9] + [START] + [POWER] ON
PM SUPPORT CODE LIST
MM-DD-YY 09:30
UNIT
DRUM
DRUM BLADE
GRID
MAIN CHARGER WIRE
SEPARATION FINGER (DRUM)
• Turn OFF the power and make sure to unplug the equipment.
(2) Perform a preventive maintenance using the following checklist and illustrations. Refer to the
Service Manual if necessary.
(3) Plug in the equipment after the maintenance has been finished. Then turn ON the power and
make some copies to confirm that the equipment is working properly.
e-STUDIO520/523/600/603/720/723/850/853
PREVENTIVE MAINTENANCE (PM)
[2]
[103]
OUTPUT PAGES PM OUTPUT PAGE
81813 150000
81813 150000
81813 150000
81813 150000
81813 150000
Fig. 4-5
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
4 - 8
07/11
[START]
[START]
DRIVE COUNTS PM DRIVE COUNTS
119758 220000
119758 220000
119758 220000
119758 220000
119758 220000