Setting Mode (08) - Toshiba e-STUDIO520 Service Handbook

2.2.5

Setting mode (08)

The items in the setting code list can be set or changed in this setting mode (08).
When the power should be turned OFF, be sure to shut down the equipment by pressing
the [ENERGY SAVER] button for a few seconds.
Procedure 1
[0][8] [Digital key]
[POWER] (Code)
* Press [FUNCTION CLEAR] to enter minus (-).
Procedure 2
[0][8] [Digital key]
[POWER] (Code)
Procedure 3
[0][8]
[Digital key]
[POWER]
(Code)
[CANCEL] or [CLEAR]
Procedure 4
[0][8] [Digital key]
[POWER] (Code)
* Press [FUNCTION CLEAR] to enter minus (-).
e-STUDIO520/523/600/603/720/723/850/853
ERROR CODE AND SELF-DIAGNOSTIC MODE
[CANCEL]
[Digital key]
[START]
*[FUNCTION CLEAR]
Sets or
changes value
[START]
Adjustment value
cannot be changed
[ENTER]
[START]
[INTERRUPT]
(Stores value in RAM)
[CANCEL]
[Digital key]
[START]
(Sub-code)
[CLEAR]
(Corrects value)
[ENTER]
or
[INTERRUPT]
(Stores value in RAM)
[CLEAR]
(Corrects value)
[ENTER]
[POWER]OFF/ON
or
[INTERRUPT]
or (Automatic setting)
[START]
[START]
[Digital key]
* [FUNCTION CLEAR]
Sets or
changes value
[CLEAR]
(Corrects value)
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
2 - 74
[POWER] OFF/ON
(Exit)
(Exit)
[POWER] OFF/ON
(Exit)
[ENTER] [POWER]
or OFF/ON
[INTERRUPT] (Exit)
(Stores value
in RAM)