General Descriptions For Pm Procedure - Toshiba e-STUDIO 5540C Service Manual

7.3

General Descriptions for PM Procedure

(1) Preparation
• Ask the user about the current conditions of the equipment and note them down.
• Before starting maintenance, make some sample copies and store them.
• See the replacement record and check the parts to be replaced in the PM support mode (6S-
2) or list printing mode (9S-103).
6S : [6] + [START] + [POWER] ON
9S-103 : [9] + [START] + [POWER] ON  [103]  [START]
PM SUPPORT CODE LIST
2011-02-09 13:16
UNIT
DRUM(K)
DRUM BLADE(K)
GRID(K)
MAIN CHARGER NEEDLE(K)
CHARGER CLEANING PAD(K)
DRUM(Y)
DRUM BLADE(Y)
GRID(Y)
MAIN CHARGER NEEDLE(Y)
CHARGER CLEANING PAD(Y)
DRUM(M)
DRUM BLADE(M)
GRID(M)
MAIN CHARGER NEEDLE(M)
CHARGER CLEANING PAD(M)
DRUM(C)
DRUM BLADE(C)
GRID(C)
MAIN CHARGER NEEDLE(C)
CHARGER CLEANING PAD(C)
• Turn OFF the power and make sure to unplug the equipment.
(2) Perform a preventive maintenance using the following checklist and illustrations.
(3) Plug in the equipment after the maintenance has been finished. Then turn ON the power and
make some copies to confirm that the equipment is working properly.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
PREVENTIVE MAINTENANCE (PM)
S/N : CLE000007 FIN S/N : FIN S/N-xxxxxxxx
TOSHIBA e-STUDIO6550C
OUTPUT PAGES PM OUTPUT PAGES DRIVE COUNTS
DEVELOP COUNTS DEVELOP COUNTS
9020 275000
9020 275000
9020 275000
9020 275000
9020 275000
6208 275000
6208 275000
6208 275000
6208 275000
6208 275000
6208 275000
6208 275000
6208 275000
6208 275000
6208 275000
6208 275000
6208 275000
6208 275000
6208 275000
1077 275000
Fig. 7-1
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
7 - 4
TOTAL : 2146
DF TOTAL : 1213
PM DRIVE COUNTS
24911 285000
24911 285000
24911 285000
24911 285000
24911 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000
21136 285000