Changing Printing Speed - Toshiba e-STUDIO520 Service Handbook

3.10.5

Changing Printing Speed

When the fuser roller temperature drops drastically during the continuous printing, the printing may be
stopped to increase the fuser roller temperature because the shortage in supply to the fuser unit,
depending of the use condition (use environment, power voltage condition, heat reserve condition of
the fuser unit).
To prevent the printing from stopping or to decrease its frequency, enable the setting of changing the
printing speed when the temperature drops, at the setting mode "08".
<Setting mode(08)>
Code
858 Changing Printing Speed (Plain paper)
859 Changing Printing Speed (Thick paper 1)
860 Changing Printing Speed (Thick paper 2)
861 Changing Printing Speed (Thick paper 3)
Notes:
1. This adjustment is valid for e-STUDIO600/720/850.
2. When the setting value "1" is selected, the printing speed slows down if the fuser roller tem-
perature drops for only 5 minutes after the warming-up time.
3. When the setting value "2" is selected, the printing speed slows down if the fuser roller tem-
perature drops.
© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Contents
3 - 55
Default
0 0: Disabled, 1: Enabled only for 5min.
2: Always enabled
0 0:Disabled, 1: Enabled only for 5min.
2: Always enabled
0 0:Disabled, 1: Enabled only for 5min.
2: Always enabled
0 0:Disabled, 1: Enabled only for 5min.
2: Always enabled
e-STUDIO520/523/600/603/720/723/850/853
Values
ADJUSTMENT
3