Configuration Of Navigation Map For Traffic System; Clearing Default User Settings - Garmin G1000 System Maintenance Manual

3.38

Configuration of Navigation Map for Traffic System

1. With the MFD in normal mode, use the GCU FMS knob to select the Navigation Map page then press
GCU MENU key to display the PAGE MENU.
2. Turn the small right knob to select or verify selected 'Map Setup' and press the ENT key and verify
TRAFFIC is selected ON.
3. Verify the flashing cursor highlights the GROUP field.
4. Turn the GCU small FMS knob to select Traffic and press ENT on GCU.
5. If not already selected, use the GCU FMS knob to make the following selections:
• TRAFFIC MODE – ALL TRAFFIC
• TRAFFIC SMBL – 300NM
• TRAFFIC LBL – 300NM
6. Return to the Map Page by pressing the GCU FMS knob or momentarily pressing and holding the
CLR key. Deactivate cursor.
3.39

Clearing Default User Settings

1. Remove power from PFD1, PFD2 and MFD by pulling the PFD1 PRI, PFD1 SEC, PFD2 and
MFD circuit breakers.
2. While holding the CLR button on PFD1, reset PFD1 PRI and PFD1 SEC circuit breakers.
3. While holding the CLR button on PFD 2, reset the PFD2 circuit breaker.
4. While holding the second key from the right side of the MFD (beginning on the right side of the
MFD, count 2 keys to the left), reset the MFD circuit breaker.
5. When prompted to clear user settings, select the YES softkey on each unit.
Page 3-52
Revision 1
G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
190-00716-01