Garmin G1000 System Maintenance Manual page 218

6.16.1
Configuration Module Checkout
If a GRS 77 AHRS Configuration Module is replaced:
All three GRS 77/GMU 44 calibration procedures must be performed. Proceed to Section 7.7.3.
If a GEA 71 Configuration Module is replaced:
Proceed to Section 7.4.1.
If only the Master Configuration Module is replaced:
New Terrain/Obstacle cards, Jeppesen Aviation Database and other optional features (i.e.
TAWS unlock card) will need to be replaced if the master configuration module is
changed. The G1000 System ID number will change to a new number when installing a
new master config module. The old Terrain and other cards will no longer work as they
will remain locked to the old System ID number.
1. Start the G1000 system in configuration mode.
2. Go to the Configuration Upload Page on PFD 1.
3. Press the UPDT CFG softkey and press ENT.
If both PFD 1 and Master Configuration Module are replaced:
New Terrain/Obstacle cards, Jeppesen Aviation Database and other optional features (i.e.
TAWS unlock card) will need to be replaced if the master configuration module is
changed. The G1000 System ID number will change to a new number when installing a
new master config module. The old Terrain and other cards will no longer work as they
will remain locked to the old System ID number.
1. The entire G1000 system must be re-configured. Insert the correct G1000 software loader card into
PFD 1.
2. Start the G1000 in configuration mode. Go to the System Upload Page on PFD 1.
3. See Section 3.9 for instructions on how to use the System Upload page. Check all configuration
files and reload them.
4. After reloading configuration files, examine the G1000 installation for any installed configuration
options. Options are listed in Section 3.9. Load optional files as necessary.
5. Continue to Section 8 and conduct the return to service checkout.
G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
190-00716-01
NOTE
NOTE
Page 6-5
Revision 1