Tcas Ii Traffic System Option Configuration; Figure 3-27, Tcas Ii System Configuration - Garmin G1000 System Maintenance Manual

3.16

TCAS II Traffic System Option Configuration

Follow this procedure to enable the Collins TCAS II traffic system function for the G1000 system if required. Do
not accomplish the GTX33/33D configuration procedure per Section 3.21.
The G1000 can only be configured for TIS or TCAS II but not both.
Performing this procedure will automatically disable the TIS function.
Coordinate this configuration with Section 7.15 "Non-Garmin Traffic System
(TCAS II) Functional Check".
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the "System Upload"
page on PFD1 using the small FMS knob.
2. Activate cursor and rotate the small FMS knob to display drop down menu. Highlight King Air - Options
and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight "TCAS II System Option". Press ENT key on PFD1.
4. Verify the "TCAS II System Option" is displayed in the "Item" window. Press "LOAD".
5. Monitor load progress. Verify software load completes without errors as indicated by the following:
• Green "PASS" in Configuration column for AIRFRAME, ALERTS, GIA 1, and GIA 2.
• "Upload Complete.............COMPLETE" in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.
Page 3-30
Revision 1
NOTE

Figure 3-27, TCAS II System Configuration

G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
190-00716-01