Figure 3-20, System Status - Garmin G1000 System Maintenance Manual

3.9.3
Software Check
Anytime software and configuration loading procedures are accomplished during maintenance, conduct a
final software review of the system.
1. Start the G1000 system in Configuration Mode as described in Section 3.7.
2. Press the small FMS knob to activate the cursor on the System Status page of the PFD or MFD.
3. The System Status page shows a list of LRUs in the LRU window. Use the FMS knob to scroll
through the list in the window and verify that the software part number and version displayed in
the DATA window matches the information in General Arrangement drawing listed in Table 1-2.
Record the results on the next page.
It is essential that the software versions be checked and matched against the listed
versions in the General Arrangement drawing listed in Table 1-2.
Configuration is a critical part of the G1000 operation and must be verified before
returning an aircraft to service.
If any software version and/or part number does not match those specified by the
General Arrangement drawing, or if the software is not successfully loaded, DO
NOT continue. Troubleshoot and resolve the issue before continuing.
Page 3-22
Revision 1

Figure 3-20, System Status

IMPORTANT!
G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
Software
190-00716-01