Garmin G1000 System Maintenance Manual page 285

Installed in the hawker beechcraft 300/b300 series king air
Hide thumbs Also See for G1000:
Table of Contents

Advertisement

7.28
GDL 59 Wi-Fi Data Link Functional Check
This check verifies GDL 59 Wi-Fi Data Link interface is configured and is functional. This check
requires an operating and available wireless network to be within range of the aircraft.
This check only verifies the data output from the G1000 equipment. Any
equipment/wiring added that is not part of the installation data will need
separate testing and verification not covered as part of this document.
1. Start the G1000 System in Normal Mode.
2. Using the large FMS knob, select the AUX page group on the MFD. Using the small FMS
knob, select the AUX-REPORT STATUS page.
3. Press the WI-FI softkey on the MFD to select the AUX – WI-FI SETUP page.
4. Press the AVAIL softkey on the MFD to display the available WI-FI networks.
5. Press the FMS knob on the GCU to activate the cursor and rotate the small FMS knob to
highlight the desired network in the AVAILABLE NETWORKS field.
6. Press the CONNECT softkey on the MFD to connect to the network. (Skip to step 12 if the
selected network is a non-secure network.)
7. If the selected network is a secure network, enter the passcode in the ENTER PASSPHRASE
field in the WPA SECURITY SETTINGS pop-up window.
8. Press the ENT key on the GCU to accept the passcode, then press the ENT key on the GCU
again.
9. When the SAVE SETTINGS pop-up window is displayed, press the ENT key on the GCU
keypad to select SAVE CONNECTION.
10. Enter the appropriate airport identifier in the SELECT AN AIRPORT TO ASSOCIATE
WITH THE CONNECTION field, then press the ENT key on the GCU to accept the
identifier.
11. With the CONNECT button highlighted, press the ENT key on the GCU to connect to the
network.
12. Press the ENT key on the GCU if the verification window "Are you sure you want to
connect?" is displayed.
13. Verify that the CONNECTION STATUS field on the AUX – WI-FI SETUP page on the
MFD indicates CONNECTED.
G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
190-00716-01
NOTE
Page 7-57
Revision 1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gfc 700

Table of Contents