Displacement Pump - Graco Reactor E-10 Instructions-Parts List Manual

For spraying or dispensing 4:1 mix ratio materials, including epoxies, polyurethane foam, and polyurea coatings. not for use in explosive atmospheres

Hide thumbs Also See for Reactor E-10:

Table of Contents

Displacement Pump

A side displacement pump repair and

parts information is included in

manual 311076, which is supplied

with your unit.

Use dropcloth or rags to protect

Reactor E-10 and surrounding area

from spills.

1. See Before Beginning Repair, page 35.

Relieve pressure, page 22.

To Remove Suction Tube

1. Loosen nut (34) and remove suction tube

(31).

313221A

To Remove Intake Valve Only

2. Disconnect suction tube.

3. Remove intake valve by hitting ears (E)

If pump is not generating any pressure,

the intake ball check may be stuck closed

with dried material.

If the pump is not generating pressure on

the downstroke, intake ball check may be

stuck open.

Either of these conditions can be serviced

with the pump in place.

firmly right-to-left with a non-sparking ham-

mer. Unscrew from pump. See manual

311076 for repair and parts.

Repair

Table of Contents