Pause (Heated Units) - Graco Reactor E-10 Instructions-Parts List Manual

For spraying or dispensing 4:1 mix ratio materials, including epoxies, polyurethane foam, and polyurea coatings. not for use in explosive atmospheres

Hide thumbs Also See for Reactor E-10:

Table of Contents

Enlarged version

Disengage piston safety lock.

Fusion

Test spray onto cardboard or plastic

sheet. Verify that material fully cures in

the required length of time, and is the

correct color. Adjust pressure and tem-

perature to get desired results. Equip-

ment is ready to spray.

Pause (Heated Units)

To bring the hose and gun back to spray

temperature after a brief break, use the fol-

lowing procedure.

Engage piston safety lock.

Fusion

Set function knob to Slow Recirc

313221A

Set Recirc/Spray valves to Recirc until

temperature readouts come back up.

If you stop spraying for more than 2 min-

utes when using an impingement mix

gun, close gun fluid valves A and B.

Doing this will keep the internal parts of

the gun cleaner and prevent crossover.

Pause (Heated Units)

Table of Contents