Repair; Before Beginning Repair - Graco Reactor E-10 Instructions-Parts List Manual

For spraying or dispensing 4:1 mix ratio materials, including epoxies, polyurethane foam, and polyurea coatings. not for use in explosive atmospheres

Hide thumbs Also See for Reactor E-10:

Table of Contents

Repair

Repairing this equipment requires access to

parts which may cause electric shock or

other serious injury if work is not performed

properly. Have a qualified electrician connect

power and ground to main power switch ter-

minals, see page 13. Be sure to shut off all

power to the equipment before repairing.

1. Flush if possible, see page 24. If not possi-

ble, clean all parts with solvent immediately

after removal.

2. Set function knob to Stop/Park

3. Shut off Motor Power. Disconnect power

supply.

4. Shut off Heater Power. Allow equipment to

cool before repairing.

5. Relieve pressure, page 22.

313221A

Repair

Table of Contents