Pressure Relief Procedure; Shutdown - Graco Reactor E-10 Instructions-Parts List Manual

For spraying or dispensing 4:1 mix ratio materials, including epoxies, polyurethane foam, and polyurea coatings. not for use in explosive atmospheres

Hide thumbs Also See for Reactor E-10:

Table of Contents

Enlarged version

Pressure Relief

Procedure

Engage piston safety lock.

Fusion

Set function knob to Stop/Park

Turn Recirc/Spray valves to Recirc.

Fluid will be dumped to pails. Pumps will

move to the bottom of their stroke.

Ensure gauges drop to 0.

For longer breaks (more than 10 minutes),

use the following procedure. If you will be

shut down for more than 3 days, first see

Flushing, page 24.

Follow all steps of Pressure Relief Pro-

cedure, at left.

If using an impingement mix gun, close

gun fluid valves A and B. Doing this will

keep the internal parts of the gun

cleaner and prevent crossover.

Shut off Heater Power (heated units

only).

Shut off Motor Power.

Shut off Compressor Power.

Remove pails from mounting bracket.

Refer to your separate gun manual and

perform the Shutdown procedure.

Pressure Relief Procedure

313221A

Table of Contents