Graco Reactor E-10 Instructions-Parts List Manual page 14

Model
120 V, 1 phase, 50/60 Hz,
three 15 ft (4.5 m) power cords,
Heated
Model
Two cord heated models
To avoid electric shock, always unplug all cords
before servicing Reactor E-10.
1
Ensure no other high amp loads are connected
while running Reactor E-10.
2
To verify separate circuits, plug in Reactor E-10
or a worklight and cycle breakers on and off.
F . 5. Use Three Separate Circuits
IG
14
Table 2: Electrical Requirements
Required Power Source
Three separate, dedicated
circuits rated at minimum of
15 A each
Table 3: Extension Cord Requirements
Cords must be 3-conductor grounded, rated for your
environment.
Heater Power
Motor Power
Power Cord Connector
Required Wire Size
Up to 50 ft (15
m) Up to 100 ft (30 m)
AWG 14
1
Compressor Power
Three NEMA 5-15T
AWG 12
2
TI12383a
313221A
Setup