Genie Z45/25J Operator's Manual page 8

Operator's Manual
SAFETY RULES
Collision Hazards
Be aware of the boom position when rotating the
turntable.
Operators must comply with employer, job site and
governmental rules regarding the use of personal
protective equipment.
Check the work area for overhead obstructions or
other possible hazards.
Be aware of crushing hazards when grasping the
platform guard rail.
Observe and use color-coded direction arrows on
the platform controls and drive chassis for drive
and steer functions.
Do not lower the boom unless the area below is
clear of personnel and obstructions.
Limit travel speed according to the condition of the
ground surface, congestion, slope, location of
personnel, and any other factors which may cause
collision.
6
Be aware of limited sight
distance and blind spots
when driving or operating.
Self-Propelled Servicing Platform
Second Edition • Fifth Printing
Do not operate a boom in the path of any crane
unless the controls of the crane have been locked
out and/or precautions have been taken to prevent
any potential collision.
No stunt driving or horseplay while operating a
machine.
Do not operate any of the machine controls when
the auxiliary platform is occupied.
Bodily Injury Hazard
Do not operate the machine with a hydraulic oil or
air leak. An air leak or hydraulic leak can penetrate
and/or burn skin.
When the engine is running, operate the machine in
a well-ventilated area to avoid carbon monoxide
poisoning.
Improper contact with components under any cover
will cause serious injury. Only trained maintenance
personnel should access compartments. Access
by the operator is only advised when performing a
pre-operation inspection. All compartments must
remain closed and secured during operation.
Component Damage Hazards
Do not use any battery or charger greater than 12V
to jump-start the engine.
Do not use the machine as a ground for welding.
Do not stand on Aircraft Protection Package.
Damage to equipment or injury to personnel may
occur.
Part No. 114047