Genie Z45/25J Operator's Manual page 31

Second Edition • Fifth Printing
Controller Fault Indicator
Light On
If the controller fault indicator light is on, push in
the red Emergency Stop button, wait a few seconds
and pull out the red Emergency Stop button to reset
the system.
If the light stays on, tag and remove the machine
from service.
Aircraft Protection Package
If the gray platform bumpers come in contact with
aircraft components, the machine will shut down
and no functions will operate.
Move the function override toggle switch to either
side to operate the machine.
Fall Protection
Personal fall protection equipment (PFPE) is
required when operating this machine.
All PFPE must comply with applicable
governmental regulations, and must be inspected
and used in accordance with the PFPE
manufacturer's instructions.
Part No. 114047
Charging the Batteries
Do not charge the batteries in hazardous locations.
Use the engine or the AC battery charger to
recharge the batteries.
Charging the Batteries with the Engine
Do not operate the engine while the machine is in
hazardous locations.
Running the engine will automatically charge the
batteries. At high idle, the engine supplies enough
power for charging and for machine functions. At
low idle, machine functions will use battery power.
All lift and drive functions can be operated while the
engine is running.
The battery charge indicator will reset when the
engine has been turned off for 2-3 minutes.
Charging the batteries with the engine does not fully
charge the batteries. Periodically, use the AC
battery charger to fully charge the batteries.
Charging the Batteries with the AC Charger
Be sure the engine is not running.
Be sure the charger lock-out switch is in the on
position.
Use the AC battery charger included with the
machine for overnight charging. The charger shuts
off automatically.
Periodically, use the AC battery charger to fully
charge the batteries.
Self-Propelled Servicing Platform
Operator's Manual
OPERATING INSTRUCTIONS
29