Genie Z45/25J Operator's Manual page 29

Second Edition • Fifth Printing
Drive Enable
Light on indicates that the boom
has moved just past either non-
steer wheel and the drive function
has been interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Engine Idle Select (rpm)
Select the engine idle speed (rpm) using the
symbols on the control panel. Engine idle speed
does not affect machine function speed.
· Rabbit and foot switch symbol:
foot switch activated high idle
· Turtle symbol: low idle and slow battery charging
· Rabbit symbol: high idle and quickest battery
charging
At high idle, the engine supplies enough power for
charging and for machine functions. At low idle,
machine functions will use battery power.
Part No. 114047
Auxiliary Platform Operation
To Raise Platform
1 Pull out the two pins that secure the auxiliary
platform to the top rail of the main platform.
2 Pull out the pin that secures the auxiliary
platform to the toeboard of the main platform.
3 Grasp the mid-rail and swing the auxiliary
platform up to a horizontal position.
4 Pull out the pins from the hooks on each side of
the auxiliary platform.
5 Rest the hooks on top of the main platform rails.
6 Insert the pins to secure the hooks to the rails.
7 Pull out the four pins on each side of the
auxiliary platform front toeboard.
Self-Propelled Servicing Platform
Operator's Manual
OPERATING INSTRUCTIONS
mid-rail
27