To Open The Gas Boiler; To Open The Switch Box Cover Of The Gas Boiler; Mounting The Indoor Unit; About Mounting The Indoor Unit - Daikin CHYHBH05AA Installer's Reference Manual

7.2.3

To open the gas boiler

2
1 Open the display cover.
2 Unscrew both screws.
3 Tilt the front panel towards you and remove the front panel.
7.2.4 To open the switch box cover of the gas
boiler
1 Open the gas boiler, see
page 23.
2 Pull the boiler controller unit forwards. The boiler controller will
tip downwards to provide access.
7.3

Mounting the indoor unit

7.3.1

About mounting the indoor unit

When
You have to mount the outdoor and indoor unit before you can
connect the refrigerant and water piping.
Typical workflow
Mounting the indoor unit typically consists of the following stages:
1 Installing the indoor unit.
CHYHBH05+08AA + EHYKOMB33A
Daikin hybrid for multi heat pump – heat pump module
4P471761-1A – 2017.10
1
"7.2.3 To open the gas boiler" on
7.3.2 Precautions when mounting the indoor
unit
INFORMATION
Also read the precautions and requirements in the
following chapters:
▪ General safety precautions
▪ Preparation
7.3.3

To install the indoor unit

1 Put the installation pattern (see box) on the wall and follow the
steps as shown below.
1
2 Fix the wall bracket to the wall with 2 M8 bolts.
3 Lift the unit.
30kg
4 Tilt the top of the unit against the wall at the position of the wall
bracket.
7 Installation
2 3
2×
Installer reference guide
23