Table of Contents
Advertisement
3.2.7 Digital Board Removal
Step 1:
Remove the sub board (Refer to section 3.2.6.)
Step 2:
Remove the engine (Refer to section 3.2.8.)
Step 3:
Remove the isolation sheet on the shield plate B.
Step 4:
Remove the four CB (M3 x 6) screws shield plate B and the digital board to the scanner.
Step 5:
Remove the two screws that secures the digital board then remove the digital board.
Digital Board
The dip of the FFC that made after optical unit and the CN1 of the digital board are connected
must be inserted the space under the engine base frame.
Fix the six screws after align the holes of shield plate B, the holes of the digital board, and the
holes of the frame.
The both sides of the FFC cable which is connected both the inverter board and the digital
board has blue indication. The blue indication sides must be face to the out side of the
scanner.
Rev. A
Figure 3-11. Digital Board Removal
ASSEMBLING POINT
DISASSEMBLY AND ASSEMBLY
Shield Plate B
Connector
Fixiing Screw
3-11
Advertisement
Chapters
Table of Contents
