Epson FilmScan 200 Service Manual page 60

FilmScan 200

When connect the lamp unit and the inverter board, align the direction of the pins of the lamp unit
and connectors of the inverter board (Refer to Figure 3-7.).

The inverter board has guide holes and these holes match with the duels on the top of the engine
unit.

Both ends of the FFC has blue guide plates. The blue guide plates must face to the outside of the
engine unit.
Assign the left and light pin-positions to the connectors.`
3-8
ASSEMBLING POINT
Lamp Unit Backside
Connector
Inverter Board
Figure 3-7. Lamp Unit Installation
Connector
Rev. A